November Haas Lathe Control Class
11-05-2019 09:00:00 - 11-06-2019 17:00:00

Introduction to the Haas Control for Lathe. This two-day class consists of hands on training for control navigation and usage. When the classroom portion is complete, students will setup and run a part on a lathe.

Class starts each day at 9:00 am and will run until 5:00 pm as needed. A one-hour break for lunch will be provided.

*** If unable to register due to class being full, please email Jsteele@championscnc.com to schedule an “Over-flow Class” ***



Address

CONTACT(s)

  • Jordan Steele
  • jsteele@championscnc.com
  • 8329645333